FrSky X4R-SB to Revolt V2 Setup


Physical Connections

1) Solder S.Bus to TX1 Pad

2) Solder VCC to VCC Pad

3) Solder Ground to Ground Pad

4) Solder S.Port to RX3

5) Bridge VCC and 5V Pads for TX1

6) Bridge INV1 and TX1

Software Configuration

7) Run Detect Receiver step in FlightOne One configuration software.

Manual Configuration

8) Go to Configuration page

9) For Receiver Protocol select SBUS TX Pin

10) For Receiver Port select UART 1

11) Under Telemetry heading, enable Taranis telemetry (RX3 Pin)


Please enter your comment!
Please enter your name here